Advanced Configuration With Wifi Connection; Connection And Configuration Mode - Urmet 1083/48 Manual De Instrucciones

3

ADVANCED CONFIGURATION WITH WiFi CONNECTION

If you decide to configure the device using advanced mode, remember that for new reconfigurations of the
essential parameters you must NOT operate in mode without WiFi, as this would overwrite the previously set
data.

3.1 CONNECTION AND CONFIGURATION MODE

A terminal (personal computer, smartphone or tablet) capable of connecting to wireless networks with a QR code
reader app installed is required to access advanced configuration of audio-video door units Ref. 1083/48, audio
door units Ref. 1083/38 and audio door units with CCTV Ref. 1083/39.
Follow the instructions below:
• To switch on the WiFi access point on the door unit, press the PROGRAM button (10) for longer than 5
seconds; confirmation of the operation is given by a sound signal (beep) and by flashing LEDs (1).
The device is then set up to provide its own connection to another device.
The device automatically switches off the WiFi access point during this step (waiting for connection)
after 10 minutes of inactivity.
• Use the terminal to detect the door unit among the available WiFi networks. The name, depending on the
model, is:
– URMET_1083_48_XXXXXXXXXXXX (for audio-video door unit)
– URMET_1083_38_XXXXXXXXXXXX (for video door unit)
– URMET_1083_39_XXXXXXXXXXXX (for audio door unit with CCTV)
Numbers XXXXXXXXXXXX indicate the MAC ADDRESS of the device shown on the back of the door
unit.
• Select the WiFi network corresponding to the door unit to be configured; the connection is confirmed by LEDs
A and C (1) which remain lit permanently.
It is not possible to connect to the WiFi access point with several terminals at the same time, as only
one terminal at a time is recognised and connected.
The device remains in this state until control
• Start the QR code reader app and scan the QR code below with the camera of your terminal or start the
browser present on the terminal and enter the IP address 19.168.4.1 in the address bar.
On some terminals it may be necessary to disable the network data of your terminal to access the
configuration web page of the device.
16
http://192.168.4.1
is selected (see below).
DS1083-099