Tabla de contenido
Idiomas disponibles
Idiomas disponibles
7.
Disconnect the network cable from the camera to switch it to WiFi mode. Press the
"
Refresh List
again when it is connected to the WiFi network.
8.
It is advisable to assign a static IP address to the camera: see section 3.3 of this
guide to perform this operation.
9.
After having installed the camera in the desired point, if it provided with autofocus
motorised lens, adjust the zoom level on the LIVE web page of the page.
4.2
MODE ACCESS POINT WIFI CONFIGURATION
This mode is used to configure the wireless network interface of the camera without wiring it to
the network. It is an alternative to section 3.1.
The camera is automatically set to Access Point mode if it was never configured in a WiFi
network.
A
PC
In this case, network configuration may be performed after having fitted and powered the camera
in its final position.
The following steps must be performed for configuration:
1.
Search from the available WiFi networks on the PC. The camera has a
"
URM_MacAddress
2.
Run steps from 1 to 6 described above in section 3.1.
3.
When the camera connects to the configured WiFi, it stops working in Access Point
mode and disconnects from the PC. For this reason, the PC must be connected to
the LAN before pressing the
detect the camera again in the network.
Run steps from 8 to 9 described above in section 3.1.
4.
14
"
(Aggiorna) button of
with
wireless
"
SSID. Select this SSID to connect the PC to the camera.
"
"
EasyTool
network
board
"
"
Refresh List
button of the
to check that the camera appears
is
needed
to
"
EasyTool
configure
it.
"
program and
DS1093-559
Tabla de contenido
