Product Identification; Unpacking; Installation; Operation - DESA Heating Products PD15EA El Manual Del Propietario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

PRODUCT
IDENTIFICATION
Body
Power Cord
4
Lighted
On/Off
Switch
www.desatech.com

UNPACKING

1. Remove all packing items applied to product
for shipment.
2. Remove all items from carton.
3. Check items for any shipping damage. If
product is damaged, promptly inform dealer
where you bought product.

INSTALLATION

1. Locate product under outdoor patio table on
hard, level, dry surface. Post of tip over switch
must be on solid surface for product to work.
Listen for the "click". See Figure 3 for switch
location.
2. Slowly lower umbrella pole into product. Do
not drop pole, it may damage product.
3. Tighten thumb screw of product to secure pole.
Pole will be approximately 7 inches higher
than if used without this product.
4. Make sure the product is in the OFF posi-
tion before plugging into a grounded GFCI
protected 120V 60 HZ outlet.
5. Avoid overloading your circuit by not using
other high wattage products in the same outlet.
At 1500 watts, this unit draw 12.5 Amps.

OPERATION

IMPORTANT: Review and under-
stand the warnings in the Safety
Information section, page 2.
They are needed to safely oper-
ate this product. Follow all local
ordinances and codes when
using this product.
1. Push lighted ON/OFF switch.
2. The power light will remain lit during
operation.
3. Stay back from product until all water or
debris has blown clear.
4. Product will warm in a few minutes.
113612-01B

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Pg15eaPl15eaPv15ea

Tabla de contenido