Tabla de contenido
Idiomas disponibles
Idiomas disponibles
WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY
SERVICE OR ADJUSTMENTS:
1. Depress clutch/brake pedal fully and set parking brake.
2. Place gearshift lever in neutral position,
3. Place attachment clutch in "DISENGAGED" position.
4. Turnignitionkey to "STOP" and remove key.
5. Ensure the blades and all moving parts have completely stopped,
6. Disconnect spark plug wire from spark plug and place wire where it cannot
come in contact with plug.
TO REMOVE
MOWER
1, Place
attachment
clutch
in "DISEN-
GAGED"
position.
2, Lower attachment
lift lever to its lowest
position.
3.
Roll belt off engine
pulley (M) and belt
keepers
((3).
4. Remove
retainer spring (K), slide collar
(L) off and push housing
guide
(P) out
of bracket.
5. Remove
clutch cable spring
(Q) from
idler arm (R).
6. Disconnect
front link (E) from mower -
remove
retainer spring and washer.
7. Go to either side of mower and discon-
nect mower suspension
arm (A) from
chassis pin (B) and rear lift link (C) from
rear mower bracket (D) - remove retainer
springs and washers,
A_kCAUTION:
After rear lift links are discon-
nected, the attachment
li_ leverwill
be spring
loaded. Have a tight grip on lift lever when
changing
position of the lever,
8. Slide mower outfrom underrights!de of
tractor.
IMPORTANT: If an attachment other than
the mower is to be mounted on the tractor,
remove the front link (E) and rear lift links
(C) from tractor and hook the clutch spring
(Q) into the cable guide on front edge of
lower dash.
TO INSTALL
MOWER
Ensure tractor is on level surface and engage
parking
brake.
I.
Lower attachment
lift lever to its lowest
position.
CAUTION:
Lift lever is spring loaded.
Have a tight grip on lift lever, lower it slowly
and engage in lowest position.
NOTE: Ensure mower side suspension
arms
(A) are pointing forward before sliding mower
under tractor,
2. Slide mower under tractor until it is cen-
tered under tractor.
03042te×
19
Tabla de contenido
