◾
Do not abuse the cord. Never use the cord for carrying,
pulling, or unplugging the charger. Keep the cord away
from heat, oil, sharp edges, or moving parts. Damaged or
EN
entangled cords increase the risk of electric shock.
◾
Avoid body contact with grounded surfaces, such
as pipes, radiators, ranges, and refrigerators. There
is an increased risk of electric shock if your body is
grounded.
◾
When operating a power tool outdoors, use an
extension cord suitable for outdoor use. Use of a cord
suitable for outdoor use reduces the risk of electric shock.
◾
The EGO charger can charge the EGO lithium-ion
battery packs listed below:
CHARGER
CH2100E
SERVICE
◾
Have your charger serviced by a qualified repair
person using only identical replacement parts. This
will ensure that the safety of the charger is maintained.
◾
When servicing a charger, use only identical
replacement parts. Follow instructions in the
Maintenance section of this manual. Use of
unauthorized parts or failure to follow Maintenance
instructions may create a risk of shock or injury.
SAFETY RULES FOR CHARGER
CAUTION:
To reduce the risk of electric shock or dam-
age to the charger and battery, charge only those lithium-ion
rechargeable batteries specifically designated on your
charger's label. Other types of batteries may burst, causing
personal injury or damage.
◾
This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
◾
Before using the battery charger, read all instructions
and cautionary markings in this manual and on the
battery charger, the battery and the product using the
battery to prevent misuse of the products and possible
injury or damage.
◾
Do not use the charger outdoors or expose it to wet
or damp conditions. Water entering the charger will
increase the risk of electric shock.
◾
Do not handle charger, including the charger plug
and charger terminals with wet hands.
4
56 VOLT RAPID CHARGER — CH2100E
BATTERY PACKS
BA1120E, BA2240E, BA2800,
BA3360, BA4200
◾
Use of an attachment not recommended or sold by
the battery-charger manufacturer may result in a
risk of fire, electric shock, or injury to persons.
◾
Recharge only with the charger specified by the
manufacturer. A charger that is suitable for one type of
battery pack may create a risk of fire when used with
another battery pack.
◾
Do not abuse the cord or charger. Never use the
cord to carry the charger. Do not pull the charger cord
to disconnect the plug from a receptacle. Damage to
the cord or charger could occur and create an electric
shock hazard. Replace damaged cords immediately.
◾
Make sure that the cord is located so that it will not be
stepped on, tripped over, come in contact with sharp
edges or moving parts, or otherwise be subjected to
damage or stress. This will reduce the risk of accidental
falls, which could cause injury and damage to the cord,
which could then result in electric shock.
◾
Keep the cord and charger away from heat to
prevent damage to housing or internal parts.
◾
Do not allow gasoline, oils, petroleum-based
products, etc. to come in contact with plastic parts.
These materials contain chemicals that can damage,
weaken, or destroy plastic.
◾
Do not operate the charger with a damaged cord or
plug, which could cause shorting and electric shock.
If damaged, have the charger repaired or replaced by an
authorized service technician at an EGO Service Center.
◾
Do not operate the charger if it has received a
sharp blow, been dropped, or has otherwise been
damaged in any way. Take it to an authorized service
technician for an electrical check to determine if the
charger is in good working order.
◾
Do not disassemble the charger. Take it to an
authorized service technician when service or repair is
required. Incorrect reassembly may result in a risk of
electric shock or fire.
◾
Unplug the charger from the electrical outlet before
attempting any maintenance or cleaning to reduce
the risk of electric shock.
◾
Disconnect charger from the power supply when
not in use. This will reduce the risk of electric shock
or damage to the charger if metal items should fall into
the opening. It will also help prevent damage to the
charger during a power surge.
◾
Risk of electric shock. Do not touch the uninsulated
portion of output connector or uninsulated battery terminal.