ROSIERES RHV994X Montaje Y Modo De Empleo página 10

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 24
Description of the hood
Fig. 1
1. Control panel
2. Grease filter
3. Grease filter release handle
4. Halogen lamp
5. Vapour screen
6. Telescopic chimney
7. Air outlet (used for filter version only)
Operation
Use the high suction speed in cases of concentrated
kitchen vapours. It is recommended that the cooker
hood suction is switched on for 5 minutes prior to
cooking and to leave in operation during cooking and
for another 15 minutes approximately after
terminating cooking.
Model with button panel
B
A
E
A
B
A. on/off light switch
B. on/off aspiration switch and minimum power selection
B+C. medium power selection aspiration switch
B+D. maximum power selection aspiration switch
E. operating gauge (foreseen in the model with round
buttons)
a
b
c
a. on/off light switch
b. off aspiration switch
c. minimum power selection aspiration switch
d. medium power selection aspiration switch
e. maximum power selection aspiration switch
D
C
C
D
e
d
Maintenance
Prior to any maintenance operation ensure that the cooker
hood is disconnected from the power supply.
Cleaning
The cooker hood should be cleaned regularly internally and
externally. Clean using the cloth dampened with neutral
liquid detergent. Do not use abrasive products.
DO NOT USE ALCOHOL!
Warning: Failure to carry out the basic standards of the
cleaning of the cooker hood and replacement of the filters
may cause fire risks.
Therefore we recommend observing these instructions.
Grease filter
Fig. 2
This must be cleaned once a month (or when the filter
saturation indication system – if envisaged on the model in
possession – indicates this necessity)
aggressive detergents, either by hand or in the dishwasher,
which must be set to a low temperature and a short cycle.
When washed in a dishwasher, the grease filter may
discolour slightly, but this does not affect its filtering
capacity. To remove the grease filter B, pull the spring
release handle.
Charcoal filter (filter version only)
Fig. 3
It absorbs unpleasant odours caused by cooking.
The charcoal filter can be washed once every two months
(or when the filter saturation indication system – if
envisaged on the model in possession – indicates this
necessity) using hot water and a suitable detergent, or in
a dishwasher at 65°C (if the dishwasher is used, select the
full cycle function and leave dishes out).
Eliminate excess water without damaging the filter, then
remove the mattress located inside the plastic frame and
put it in the oven for 10 minutes at 100° C to dry
completely. Replace the mattress every 3 years and when
the cloth is damaged. Remove the filter holder frame by
turning the knobs (g) 90° that affix the chimney to the
cooker hood.
Insert the pad (i) of activated carbon into the frame (h) and
fit the whole back into its housing (j).
It is possible to use a traditional carbon filter, neither
washable nor regenerable, to be replaced every 3 - 4
months.
The filter holder frame of the carbon filter is welded
together; the eventual frame supplied with the hood is not,
therefore, to be used.
Insert it into its housing and fix it turning the 2 plastic
knobs.
10
using non
Tabla de contenido
loading

Tabla de contenido