Thermal Paper Specifications; Replacement Of The Paper Roll In The Printer - Terragene Bionova IC10/20FR Manual Del Operador

Instructions for use
Do not remove or change placement of BI once
the reading process has begun. If this occurs,
results may be invalidated.
Use a non-sterilized biological indicator as a
positive control every time a processed indica-
tor is incubated. For more information refer to
the Positive Control section of this user guide.
7-Place the rapid BI in a reading position and wait for
the result. Reading will start automatically. Immedia-
tely after placing the BI in a position, an alarm will
sound indicating that reading has successfully began
and the position LED will blink until the result is in-
formed.
8-When a positive result is detected, the red light and
the audible alarm will turn on. 30 seconds after remo-
ving the IB from the incubation position, the alarm
and the red light will turn off automatically and the
position will be available to start a new reading.
The negative BIs will be informed with a green light
in the corresponding position.The Green light will re-
main on for up to 30 seconds after the BI is withdrawn
from the reading position. The incubator will inform
results within 30 min. (60 ºC),1 h. (60 ºC), 2 hs. (60 °C),
3 hs. (60 ºC) or 4 hs. (37 ºC) , according to the program
selected.
These periods of incubation are the time-limits used
by the equipment to inform the fl uorescence fi nal
readout. This limit is independent of any position.
9-Every time a positive result is detected, it will be
informed through the printing of the corresponding
ticket and with an audible alarm. The alarm can be
cancelled by pressing the button
Time needed for printing negative result tickets is 30
min. (60 ºC), 1 h. (60 ºC), 2 hs. (60 °C), 3 hs. (60 ºC), 4
hs. (37 ºC).
10-To register the tickets, press the button for paper
traction, take the paper and press down for the paper
to be cut with the serrated edge of the printer.
NOTE: If the paper runs out, the auto-reader will save
the results until a new paper roll is loaded (see Repla-
cement of the paper roll in the printer). The printer uses
thermal paper rolls.
BIONOVA IC10/20FR
BIONOVA
RAPID READOUT INCUBATOR
RAPID READOUT INCUBATOR
PROGRAM: XX/XX
PROGRAM: XX/XX
DATE: DD/MM/AAAA
DATE: DD/MM/AAAA
START TIME: HH:MM
START TIME: HH:MM
READOUT TIME: HH:MM
READOUT TIME: HH:MM
SAMPLE TUBE: NN
SAMPLE TUBE: NN
POSITIVE
CANCELED
POSITIVE CANCELED
.
IC10/20FR BIONOVA IC10/20FR
RAPID READOUT INCUBATOR
PROGRAM: XX/XX
DATE: DD/MM/AAAA
START TIME: HH:MM
READOUT TIME: HH:MM
SAMPLE TUBE: NN
NEGATIVE
NEGATIVE
IC10/20FR Page 7
Thermal paper specifi cations
Recommended paper: JUJO AF50KSE3 or similar (or-
der code ICTP).
Paper width
Maximum paper thickness
Maximum diameter size

Replacement of the paper roll in the printer

The printer uses thermal paper rolls.
To replace the paper roll, open the prin-
1
ter door by pulling the handle of the cover.
Remove the spent roll.
2
Place the new paper roll with the outer
side down.
Close the printer co-
3
ver by pressing on the
sides of the lid.
58 mm
60 g/m2
50 mm