Display Backlight - Denver Electronics DAB-33 Manual Del Usuario

DENVER DAB-33
Front view
1
1. SPEAKER 7. PRESET BUTTON
2. STANDBY BUTTON 8. SELECT BUTTON
3. TUN/CH▲ BUTTON 9. TUN/CH▼ BUTTON
4. LCD DISPLAY 10. MODE BUTTON
5. VOL+ BUTTON 11. VOL- BUTTON
6. MENU/INFO BUTTON
Side view
12
DC
DC 6V
13
12. HEADPHONE JACK 14. ANTENNA
13. DC INPUT SOCKET 15. BATTERY DOOR
EN-1
2 3 4 5
STANDBY TUN/CH VOL+
MENU/INFO TUN/CH VOL-
PRESET SELECT MODE
6 7 8 9 10 11
Rear view
14
15
DENVER DAB-33
SWITCHING YOUR RADIO ON FOR THE FIRST TIME
AC Operation
1. Insert the DC power jack of AC/DC adaptor to the DC input socket located
at the right of the radio.
2. Plug the AC/DC Adaptor to the AC mains outlet.
3. Press the STANDBY to turn the radio on.
Remarks: If the AC Adaptor voltage is over than 6V, it will possible make the
line damage.
DC (battery) operation
1. Ensure the AC/DC adaptor is disconnected from the radio and AC mains.
2. Installed the batteries (4×1.5V UM3/AA battery) into the battery
compartment.
3. Press the STANDBY to turn the radio on.
Remarks: To obtain the best performance in DC operation, the use of alkaline
batteries is highly recommended.

Display backlight

When the radio is in AC mode, the display backlight will be full brightness all
the time.
When the radio is in DC battery operation, the display backlight will be turned
on to full brightness for around 10 seconds and then go to dim, it will then be
turned on to full brightness again for 10 seconds on every key press. In STANDY
mode, the radio and display backlight will be turn off.
DAB mode
Press the STANDY button to turn the unit on, it will automatically enter into the
DAB mode and perform auto scan function, During the scan the display show
"Scanning..." together with a slide bar that indicates the progress of the scan
and the amount of stations that have been found so far.(F.1) (F.2)
F.1
Welcome !
Digital Radio
EN-2
F.2
Scanning . . . 0