Preparations; General Remarks - Carson BLUSTER 250 SE Manual De Instrucciones

e. Preparations
GB

General remarks

• If you have no or little experience with airplane models, you
should first practice with a Flight simulation program.
• Seek advice from an experienced R/C user for the first few
attempts.
• Acquaint yourself with the control functions of the
transmitter.
• Begin your flight experiments standing behind the model,
the line of sight in the flight direction. In this case, the control
reaction is the same as the direction of control.
Furthermore acquaint yourself with the control of the model as
it comes towards you (side-inverted reaction to the direction of
control)!
Lipo Balance Charger
Inserting the battery into the model
1. Pull the hood carefully away from the hood retainers on the
right and left-hand side.
2. You can now push the lithium-polymer battery into the
chassis horizontally from the front.
3. Connect the battery to the flight controller
(make sure beforehand that the transmitter is switched on).
12 CARSON 3D Helicopter Bluster 250se 50 050 7028
Charging the lithium-polymer flight
battery.
Always charge the lithium-polymer battery out of the model in/
on a fireproof base.
1. Connect the power supply to the lithium-polymer balance
charger.
2. Plug the power supply cable into a mains socket.
3. Connect the white connector of the lithium-polymer battery
to the socket of the lithium-polymer charger.
4. Ensure that the plug-in connections make a secure contact
to prevent short-circuiting.
5. Do not cover the battery up under any circumstances.
The temperature of the battery may not exceed 60 °C during
the charging process. The charging process is complete when
the green LED lights up on the balance charger.
• Connect the lipo balance charger to the power
supply's cable.
• Connect the lipo battery's white balance
connector to the lipo balance charger.
• The battery is completely charged when all
3 leds flash up green.