Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
TROUBlESHOOTING GUIDE
Problem
Power LED indicator
will not come on
"Ice Full" LED
indicator is on
Ice cubes in storage
compartment but
do not come out the
dispenser
"Add Water" LED
indicator is on
Ice making cycle is
normal but no ice is
made
Solid block of ice
forms on evaporator
Note: There is protective circuitry inside this icemaker
to protect the circuitry from overheating and the
icemaker will automatically shut down to prevent
damage if activated. Please disconnect power cord
and restart after 30 minutes of cooling down time.
For Haier Customer Service, please call: 1-877-337-3639
10
Possible Causes
Plug disconnected from wall
outlet
Storage compartment is full
Transparent hatch is open
Auger in ice storage
compartment is blocked
Water reservoir is empty or
water level is low
Ambient temperature or water
temperature inside reservoir is
to high
Refrigerant liquid leakage.
Pipe in the cooling system is
blocked.
Ice dispensing not complete
from storage compartment
Solution
Check that unit is plugged into
standard 120V, 60 Hz outlet.
Also make sure outlet has
power and circuit breaker is
not tripped.
Remove ice from storage
compartment via the dispenser
Close hatch securely, resetting
safety switch and reactivating
auger
Release ice dispenser paddle,
wait 10 seconds, push ice
dispenser paddle forward
again
Use provided funnel to add
water to reservoir on side of
unit.
Operate ice makers at
ambient temperature below
90˚ and pour colder water
into reservoir.
Turn power off, unplug unit
and contact a qualified
technician.
Turn power off, unplug unit
and contact a qualified
technician.
Unplug and allow ice to melt
(never use sharp object to
remove ice).
Tabla de contenido
