Idiomas disponibles
Idiomas disponibles
support.dell.com
5.
Press in on the release latch on each extended slide and push the chassis into
the rack.
6.
Tighten the captive thumbscrews on each side of the front chassis panel to
secure the system to the rack.
,QVWDOOLQJ WKH &DEOH0DQDJHPHQW $UP
To install the cable-management arm on the back of the, perform the following steps:
1.
Facing the back of the rack cabinet, locate the threaded hole on the back of the
slide assembly and secure the end of the cable-management arm (the end having
a bracket and captive thumbscrew) to the right side vertical rail (see Figure 1-11).
The bracket snaps into the square mounting holes on the vertical rail and is
secured with a captive thumbscrew.
captive
fastener
)LJXUH ,QVWDOOLQJ WKH &DEOH0DQDJHPHQW $UP
2.
Align the free end of the cable-management arm (the end with the pin and cap-
tive thumbscrew) to the back end of the right (or left) side inner rail (as viewed
from the back) of the.
3.
Secure the cable-management arm to the inner rail with the captive thumbscrew
(see Figure 1-11).
4.
Attach the network cable to the RJ-45 connector on the back of the system.
pin
Dell PowerVault 705N Rack Installation Guide
1-13
