The First Wash Cycle; Drainage And Electrical Connections; Technical Details; Wixxl 86 - Indesit WIXXL 86 Manual De Instrucciones

Drainage connections
B
A
The free end of the hose should not be under water.
! We advise against the use of hose extensions. In
case of absolute need, the extension must have the
same diameter as the original hose and must not
exceed 150cm in length.
Electrical connections
Before plugging the appliance into the mains socket,
make sure that:
• the socket is earthed and in compliance with the
applicable law.
• the socket is able to sustain the appliances
maximum power load indicated in the Technical
Details table (on the right).
• the supply voltage is included within the values
indicated in the Technical Details table (on the right).
• the socket is compatible with the washing machines
plug. If this is not the case, replace the socket or
the plug.
! The washing machine should not be installed in an
outdoor environment, not even when the area is
sheltered, because it may be very dangerous to leave
it exposed to rain and thunderstorms.
! When the washing machine is installed, the mains
socket must be within easy reach and should be
connected to a suitable electrical supply.
! Do not use extensions or multiple sockets.
! The power supply cable must never be bent or
dangerously compressed.
! The power supply cable must only be replaced by an
authorised serviceman.
! The company denies all liability if and when these
norms are not respected.
A. Connect the drain
hose, without kinking it,
to a draining duct or a
wall drain fixed at a
height between 65 and
100cm from the floor.
B. Alternatively, place it
over the edge of a basin,
sink or tub, fastening the
hose supplied to the tap.

The first wash cycle

Once the appliance has been installed and before you
use it for the first time, run a wash cycle without
detergent and no laundry, setting the 90°C
programme without a pre-wash cycle.

TECHNICAL DETAILS

Model

WIXXL 86

59.5 cm wide
85 cm high
Dimensions
52.5 cm deep
Capacity from 1 to 7 kg
Electric voltage 220 - 240 volts 50 Hz
absorbed power 1700 – 2100 W
connections
maximum pressure 1 MPa (10 bar)
Water
minimum pressure 0,05 MPa (0,5 bar)
connection
drum capacity 53 litres
Spin speed up to 800 rpm
Control
programmes
programme 2 with temperature set to
according to
60°C run with a load of 7 kg.
the IEC456
directive
This appliance is compliant with the
following European Community
directives:
- 73/23/CEE of 19/02/73 (Low Voltage)
and subsequent amendments
- 89/336/CEE of 03/05/89
(Electromagnetic Compatibility) and
subsequent amendments
GB
3