Campbell Hausfeld CL0060 Manual Del Usuario página 7

General Troubleshooting Guide
Symptom Possible Cause(s)
Tool runs slowly 1. Grit or gum in tool
or will not operate
2. No oil in tool
3. Low air pressure
4. Air hose leaks
5. Pressure drops
6. Worn rotor blade in
7. Worn ball bearing in
Moisture blowing 1. Water in tank
out of tool
2. Water in the air
Corrective Action
1. Flush the tool with Campbell Hausfeld air
2. Lubricate the tool according to the lubrication
3. Adjust the compressor regulator to tool
4. Tighten and seal hose fittings if leaks are
5. a. Be sure the hose is the proper size. Long
6. Replace rotor blade
motor
7. Remove and inspect bearing for rust, dirt
motor
1. Drain tank. (See air compressor manual). Oil
2. a. Install a water separator/filter. NOTE:
lines/hoses
www.ch-commercial.com
tool oil, gum solvent, or an equal mixture of
SAE 10 motor oil and kerosene. If Campbell
Hausfeld oil is not used, lubricate the tool
after cleaning
instructions in this manual
maximum working pressure while the tool is
running free
found
hoses or tools using large volumes of
air may require a hose with an I.D. of
1/2 inch or larger depending on the total
length of the hose
b. Do not use a multiple number of hoses
connected together with quick connect
fittings. This causes additional pressure
drops and reduces the tool power.
Directly connect the hoses together
and grit or worn race. Replace or clean and
regrease bearing with bearing grease
tool and run until no water is evident. Oil tool
again and run 1-2 seconds
Separators only work properly when
the air passing through the separator is
cool. Locate the separator/filter as far as
possible from the compressor.
b. Install an air dryer
CL0060
7