Gima ECG80A Instrucciones De Uso página 32

1. Patient cabling indicator column:
Press the button
the guide arrow in the column just turning (for example:
the button
the instrument switches to the corresponding patient cable inspection.
The relevant patient cable No. just turn when choosing the patient cable.
Press I II III aVR aVL aVF Vl V2 V3 V4 V5 V6 to change the order.
2. System state information column:
Press the button
the guide arrow in the column just turning (for example:
the button
read-only.The state and other indicator information are all read-only.
Mode Conversion: shows the mode conversion of the systemic lead,
it divides into Auto lead conversion (AUTO) and Manual lead conversion
(MANU).
Leading condition indication: it will show "NORM"when the leads collecting
signals normally, and "OVER" when the leads fall off or the collected signals
too big and results in system saturation.
3. Leads state indication:
When the leads state is "NORM", you can print the ECG.
When the leads state is "OVER", you can't print the ECG, please check
whether electrodes are palced well.
When the leads state is "SAT", printed ECG is disordered,please check
whether electrodes are palced well.
When the leads state is "DROP", leads shown on the screen have been off.
Please reconnect them.
4. Printing:
Under this conditions, press
information setting and the ECG waveform; press
the printer.
Attention: When there is no paper in the paper cabinet, the instrument will
indicate you to install the paper when you press the
followings. Press
5. Calibrating:
Press button to print a l mV standard voltage mark in order to observe
the current sensitivity directly.
The LCD will display the following picture when in calibrating process:
ENGLISH
to choose the patient cabling indictor column,
to choose the corresponding patient cable,
to choose the patient cabling indictor column,
to switch the relevant information, this column is
to startup the printer's printing-system
button to return after installing paper.
), then press
), then press
again to close down
or the button as
32