Air Filter; To Clean The Air Filter; Bevel Gear; Two Piece-Shaft - Husqvarna 535LK Manual Del Usuario

Ocultar thumbs Ver también para 535LK:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

a) Make sure that the idle speed is correctly
adjusted.
b) Make sure that the fuel mixture is correct.
c) Make sure that the air filter is clean.
If the spark plug is dirty, clean it and make sure that
the electrode gap is correct, see
page 20 .
Replace the spark plug if it is necessary.

Air filter

Remove dust and dirt from the air filter to keep it clean in
order to prevent:
Carburettor malfunctions.
Starting problems.
Loss of engine power.
Unnecessary wear to engine parts.
Too much fuel consumption.
Clean the air filter at an interval of 25 hours, or more
regularly if conditions are unusually dusty.

To clean the air filter

CAUTION: A air filter that is damaged, very
dirty or soaked with fuel must always be
replaced.
If you use an air filter for a long time it cannot be fully
cleaned. Replace the air filter with a new one at regular
intervals.
1. Move the choke lever up, to close the choke valve.
331 - 003 -
Technical data on
2. Remove the air filter cover and remove the air filter.
3. Clean the air filter with warm soap water. Make sure
that the air filter is dry before you install it.
4. Replace the air filter if it is too dirty to fully clean it.
Always replace a damaged air filter.
5. Also clean the inner surface of the filter cover. Use
air or a brush.
6. Do a check of the rubber sealing surface. Replace
the filter on the rubber seal if it is damaged.
7. Make sure that the filter is dry before you assemble
it.

Bevel gear

The bevel gear is filled with the right quantity of grease
at the factory. But, before you use the product, make
sure that the bevel gear is 3/4 full with grease. Use
Husqvarna special grease.
The grease in the bevel gear does not need to be
changed unless repairs are carried out.

Two piece-shaft

Apply grease to the end of the drive shaft after each 30
hours of operation. There is a risk that the drive shaft
ends (splined coupling) on models with two-piece shafts
will seize if they are not lubricated regularly.
17
Tabla de contenido

Solución de problemas

loading

Tabla de contenido