Push-Button Ignition System Operations (Q300); Electronic Ignition System Operations (Q320) - Weber Q300 Guia Del Propietario

Push-button iGnition sYstem oPeRAtions (Q300)

If the push-button ignition system fails to ignite, be sure there is gas flow by attempting to
match light your burners. Refer to "MANUAL IGNITION." If match lighting is successful,
the problem lies in the ignition system.
m wARninG: All gas controls and supply valves should be in
the off position.
• Check that both ignition wires are attached properly to igniter electrodes (1).
• Verify that the ignition button pushes in, clicks, and returns to the out position.
if the ignition system still fails to light, contact the Customer service
Representative in your area using the contact information on our web site. log
onto www.weber.com .
®
◆

eleCtRoniC iGnition sYstem oPeRAtions (Q320)

If the electronic ignition system fails to ignite, be sure there is gas flow by attempting to
match light your burners. Refer to "MANUAL IGNITION." If match lighting is successful,
the problem lies in the electronic ignition system.
m wARninG: All gas controls and supply valves should be in
the off position.
• Check that both the black (1) and white (2) wires are attached properly to the igniter
electrodes on the ignition module.
• Verify that the AAA battery (alkaline only) is in good condition and installed correctly.
Some batteries have a plastic protective wrap around them. This plastic must be
removed. Do not confuse the plastic protective wrap with the battery label.
• Make sure the electronic ignition button is working by listening and looking for sparks
at burner.
if the electronic ignition system still fails to light, contact the Customer service
Representative in your area using the contact information on our web site. log
onto www.weber.com .
®
◆
34
mAINTENANcE
1
1
2
1