Campbell Hausfeld XT001000 Manual De Instrucciones página 12

GENERAL TROUBLESHOOTING GUIDE
SYMPTOM
Tool runs slowly or will
not operate
Moisture blowing out
of tool
POSSIBLE CAUSE(S)
1. Grit or gum in tool
2. No oil in tool
3. Low air pressure
4. Air hose leaks
5. Pressure drops
1. Water in tank
2. Water in the air lines/hoses
CORRECTIVE ACTION
1. Flush the tool with Campbell
Hausfeld air tool oil, gum solvent, or
an equal mixture of SAE 10 motor
oil and kerosene. Lubricate the
tool after cleaning with Campbell
Hausfeld (or comparable) air tool oil.
2. Lubricate the tool according to
the lubrication instructions in this
manual.
3. a. Adjust the regulator on the tool
to a higher setting.
b. Adjust the compressor regulator
to 90 PSI while the tool is running
free.
4. Tighten and seal hose fittings, if leaks
are found.
5. a. Be sure the hose is the proper
size. Long hoses or tools using
large volumes of air may require
a hose with an I.D. of 1/2 inch or
larger depending on the total
length of the hose.
b. Do not use a multiple number of
hoses connected together with
quick connect fittings. This causes
additional pressure drops and
reduces the tool power. Directly
connect the hoses together.
1. Drain tank. (See air compressor
manual). Oil tool and run until no
water is evident. Oil tool again and
run 1-2 seconds.
2. a. Install a water separator/filter.
NOTE: Separators only work
properly when the air passing
through the separator is cool.
Locate the separator/filter as far
as possible from the compressor.
b. Install an air dryer.
10