Replacing The Lamp; Installation - Electrolux EJN2301AOW Manual Del Usuario

Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.

6.1 Replacing the lamp

6.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

7. INSTALLATION
WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
Possible cause
The melting water outlet
does not flow in the evap-
orative tray above the
compressor.
The temperature regulator
is not set correctly.
The temperature regulator
is not set correctly.
1.
2.
3.
4.
5.
6.
7.
8.
3.
the climate class indicated on the rating
plate of the appliance:
Solution
Attach the melting water
outlet to the evaporative
tray.
Set a higher temperature.
Set a lower temperature.
Disconnect the mains plug from the
mains socket.
Remove the screw from the lamp
cover.
Remove the lamp cover (refer to the
illustration).
Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household applian-
ces. (the maximum power is shown
on the lamp cover).
Install the lamp cover.
Tighten the screw to the lamp cover.
Connect the mains plug to the mains
socket.
Open the door. Make sure that the
lamp comes on.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH 11