Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Important Safety Information (Continued)
Maximum operating pressure is 135 psi for single stage compressors. Do not
operate with pressure switch or pilot valves set higher than 135 psi (single stage).
•
Never attempt to adjust ASME safety valve. Keep safety valve free from paint and other accumulations.
Never attempt to repair or modify a tank! Welding, drilling or any other modification will
weaken the tank resulting in damage from rupture or explosion. Always replace worn, cracked
or damaged tanks.
Drain liquid from tank daily.
•
Tanks rust from moisture build-up, which weakens the tank. Make sure to drain tank regularly and
inspect periodically for unsafe conditions such as rust formation and corrosion.
•
Fast moving air will stir up dust and debris which may be harmful. Release air slowly when draining
moisture or depressurizing the compressor system.
Spraying Precautions
Do not spray flammable materials in vicinity of open flame or near ignition sources including
the compressor unit
•
Do not smoke when spraying paint, insecticides, or other flammable substances.
•
Use a face mask/respirator when spraying and spray in a well ventilated area to prevent health and fire
hazards.
•
Do not direct paint or other sprayed material at the compressor. Locate compressor as far away from
the spraying area as possible to minimize overspray accumulation on the compressor.
•
When spraying or cleaning with solvents or toxic chemicals, follow the instructions provided by the
chemical manufacturer.
The DANGER, WARNING, CAUTION, and NOTICE notifications and instructions in this manual
cannot cover all possible conditions and situations that may occur. It must be understood by the
operator that caution is a factor which cannot be built into this product, but must be supplied by
Save These Instructions
Do Not Discard
the operator.
4
Tabla de contenido
