Tabla de contenido
Idiomas disponibles
Idiomas disponibles
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and the receiver.
. Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment. This Class B digital apparatus complies with Canadian ICES-003.
FOR ALL DOUBLE-INSULATED LAWN MOWERS
1. Replacement Parts. When servicing use only identical replacement parts.
2. Polarized Appliance Connections
To reduce the risk of electric shock, this appliance has a polarized plug
(one blade is wider than the other) and will require the use of a polarized
extension cord. The appliance plug will fit into a polarized extension cord
only one way. If the plug does not fit fully into the extension cord, reverse
the plug. If the plug still does not fit, obtain a correct polarized extension
cord. A polarized extension cord will require the use of a polarized wall
outlet. This plug will fit into the polarized wall outlet only one way. If the
plug does not fit fully into the wall outlet, reverse the plug. If the plug
still does not fit, contact a qualified electrician to install the proper wall
outlet. Do not change the equipment plug, extension cord receptacle, or
extension cord plug in any way.
WARNING: GENERAL SAFETY WARNINGS AND
INSTRUCTIONS FOR ALL MOWERS
• THIS TOOL CAN BE DANGEROUS. Follow all warnings and Safety
Instructions in this manual. The operator is responsible for following
warnings and instructions in this manual and on unit. Restrict use of
this mower to persons who read, understand and follow warnings and
instructions in this manual and on unit.
• Avoid Dangerous Environment – Don't use lawn mowers in damp or
wet locations.
• Don't Use In Rain.
• Keep Children Away – All visitors should be kept a safe distance from
work area.
• Dress Properly – Do not wear loose clothing or jewelry. They can
be caught in moving parts. Use of rubber gloves and footwear is
recommended when working outdoors.
• Use Safety Glasses – Always use face or dust mask if operation is dusty.
• Use Right Appliance – Do not use lawn mower for any job except that
for which it is intended.
• Ground Fault Circuit Interrupter (GFCI) protection should be
provided on the circuit(s) or outlet(s) to be used for the lawn mower.
Receptacles are available having built-in GFCI protection and may be
used for this measure of safety.
WARNING:
•
To prevent electric shock use only with an extension
cord suitable for outdoor use, such as SW, SOW, STW, STOW, SJW,
SJOW, SJTW, or SJTOW.
• USE OF EXTENSION CORDS
Make sure the extension cord is in good condition before using. Always
use the proper size extension cords with the tool – that is, proper wire
size for various lengths of cord and heavy enough to carry the current
the tool will draw. Use of an undersized cord will cause a drop in line
voltage resulting in loss of power and overheating. For proper size cords
see chart below. To reduce the likelihood of disconnection of lawn
mower cord from the cord set during operating:
Minimum Gauge for Cord Sets
Volts
120V
0-25
(0-7,6m) (7,6-15,2m) (15,2-30,4m) (30,4-45,7m)
240V
0-50
(0-15,2m) (15,2-30,4m) (30,4-60,9m) (60,9-91,4m)
Ampere Rating
More
Not more
Than
Than
0
-
6
18
6
-
10
18
10
-
12
16
12
-
16
14
Total Length of Cord in Feet
26-50
51-100
101-150
51-100
101-200
201-300
American Wire Gauge
16
16
14
16
14
12
16
14
12
12
Not Recommended
i) Make a knot as shown in Figures A and A1, or
ii) Use one of the plug-receptacle retaining straps or connectors
described in this manual.
A
Appliance
Cord set
cord
Tie cord as shown
Don't Abuse Cord – Never pull lawn mower by cord or yank it to
disconnect from receptacle. Keep cord from heat, oil, and sharp edges.
• Don't Force Lawn Mower – It will do the job better and safer at the
rate for which it was designed.
• Don't Overreach – Keep proper footing and balance at all times.
• Stay Alert – Watch what you are doing. Use common sense. Do not
operate lawn mower when you are tired.
• Disconnect Lawn Mower – Disconnect the lawn mower from the
power supply when not in use, before servicing, when changing
accessories such as blades, and the like.
• Store Idle Lawn Mower Indoors – When not in use, lawn mower should
be stored in an indoor dry and locked-up place – out of reach of children.
• Maintain Lawn Mower With Care – Keep cutting edges sharp and
clean for best and safest performance.
Follow instructions for lubricating and changing accessories.
Inspect lawn mower cord periodically and if damaged, have it repaired
by an authorized service facility. Inspect extension cords periodically and
replace if damaged. Keep handles dry, clean, and free from oil and grease.
• Keep guards in place and in working order.
• Keep blades sharp.
• Keep hands and feet away from cutting area.
• Objects struck by the lawn mower blade can cause severe injuries
to persons. The lawn should always be carefully examined and
cleared of all objects prior to each mowing.
• If lawn mower strikes a foreign object, follow these steps:
• Stop lawn mower. Release the switch
• Unplug power cord.
• Inspect for damage.
• Repair any damage before restarting and operating the lawn mower.
• Use identical replacement blades only
SAVE THESE INSTRUCTIONS
DANGER: ADDITIONAL WARNINGS FOR MOWERS
• CHECK FOR DAMAGED PARTS. Before further use of the mower,
a guard or other part that is damaged should be carefully checked
to determine that it will operate properly and perform its intended
function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other conditions that may
affect their operation. A guard or other part that is damaged should be
properly repaired or replaced by an authorized service center unless
otherwise indicated elsewhere in this manual.
• REPAIRS AND SERVICE. Repairs, maintenance and any adjustments
not specified in this manual should be performed by BLACK+DECKER
authorized service centers or other qualified service organizations,
always using identical replacement parts.
WARNING:
Some dust created by this product contains chemicals
known to the State of California to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
• compounds in fertilizers
• compounds in insecticides, herbicides and pesticides
• arsenic and chromium from chemically treated lumber
To reduce your exposure to these chemicals, wear approved safety
equipment such as dust masks that are specially designed to filter out
microscopic particles.
The label on your tool may include the following symbols.
V ................. volts
Hz ............... hertz
min .............. minutes
or DC .. direct current
................ Class II Construction
................ safety alert symbol
............ Read instruction manual before use
................ Use proper eye protection
3
•
A1
Connect plug and receptacle
A...............amperes
W..............watts
or AC...alternating current
no..............no load speed
...............earthing terminal
RPM or .../min .... revolutions or
reciprocations per minute
...Use proper respiratory protection
....Use proper hearing protection
Tabla de contenido
