Environmental Protection - Worx WX22AG Manual Original

Both carbon brushes should be replaced at the
same time. Use only identical carbon brushes.
15. TO REPLACE THE BRUSHES
(See Fig.I2)
Remove the screw securing the motor brush
cover. Remove the cover, gently lift out, and
pull the spade connector free. Hold back the
coil spring and slide the worn brush out of
the housing, carefully release the spring.
Locate the replacement brush, (in the same
orientation) whilst again holding back the coil
spring. Ensure the brush is located and free
to move, release the spring, it should now sit
within the groove on the brush. Re-attach the
spade connector to the terminal, replace the
cover and secure.
WORKING HINTS FOR YOUR
ANGLE GRINDER
1. Always start at no load to achieve
maximum speed then start working.
2. Do not force the disc to work faster,
14
reducing the Disc's moving speed means
longer working time.
3. Always work with a 15-30 angle between
disc and workpiece. Larger angles will
cut ridges into the workpiece and affect
the surface finish. Move the angle grinder
across and back and forth over the
workpiece.
4. When using a cutting disc never change the
cutting angle otherwise you will stall the
disc and angle grinder motor or break the
disc. When cutting, only cut in the opposite
direction to the disc rotation. If you cut in
the same direction as the disc rotation the
disc may push itself out of the cut slot.
5. When cutting very hard material best
results can be achieved with a diamond
disc.
6. When using a diamond disc it will become
very hot. If this happens you will see a full
ring of sparks around the rotating disc.
Stop cutting and allow to cool at no load
speed for 2-3 minutes.
7 . Always ensure the workpiece is firmly held
or clamped to prevent movement.
Angle grinder
MAINTENANCE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.
TROUBLESHOOTING
Although your new angle grinder is really
very simple to operate, if you do experience
problems, please check the following:
1. If your grinder will not operate check the
power at the main plug.
2. If your grinder wheel wobbles or vibrates,
check that outer flange is tight, check that
the wheel is correctly located on the flange
plate.
3. If there is any evidence that the wheel
is damaged do not use as the damaged
wheel may disintegrate, remove it and
replace with a new wheel. Dispose of old
wheels sensibly.
4. If working on aluminum or a similar soft
alloy, the wheel will soon become clogged
and will not grind effectively.
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
EN