Brita PURITY 1200 Clean Manual De Instrucciones página 16

1x fi lter cartridge
2
marking on PURITY 1200 Clean Extra fi lter cartridge.
1x manual
1x carbonate hardness test or total hardness test
1x sticker for Service Pass, Note: Light blue sticker for PURITY 1200 Clean, red sticker for
PURITY 1200 Clean Extra.
1x reducer 1"– 3/4"
1x flush valve with flush hose
If part(s) of the delivery scope are missing, please contact your local BRITA Offi ce (see
back of cover).
4.2 Assembly of the pressure vessel and the pressure vessel lid
•
•
•
•
•
• Press the pressure vessel lid
4.3 Assembly of inlet and outlet hoses
Note: The inlet and outlet hoses are not included in the standard scope of delivery. The
use of BRITA hose sets is recommended (Chapter 11).
• Fit inlet hose
5
of the connector head
Note: Inlet "IN" and outlet "OUT" of the connector head
O-rings as seals, therefore no additional fl at seals may be used here. Make sure that
the O-rings are seated correctly.
Caution: The max. tightening torque at the 1" and 3/4" connections must not exceed
!
15Nm! Only hose connections with fl at seals may be used. Hoses with conical screw
connections damage the connections of the fi lter head and invalidate any guarantee
claims! Before assembly, note the direction of fl ow on the upper side of the fi lter head,
IN = water inlet, OUT = water outlet. Prior to installation, note installation dimensions
and operating position (Chapter 10). If no original hoses are used, the 1"- 3/4"
supplied must be used to ensure correct sealing of the return valve.
14
, Note: Blue marking on PURITY 1200 Clean fi lter cartridge, Red
Stand on the kick loops
Lift the pressure vessel
handles are over the kick loops
11
Remove the transport protective cap
Check the O-ring seal of the fi lter cartridge
groove, dirt and damage. Note: The cartridge seat has been
lubricated with food-safe lubricant at the factory.
Stand on the kick loops
vessel lid on the pressure lid
3
marking on the lid handle
down and turn clockwise until the lock engages
3
at the inlet of the connector head
.
4
with both feet.
9
and turn it clockwise until the mantle
1
.
9
from the fi lter cartridge.
12
2
with both feet and place the pressure
9
. The positioning of the arrow
1
must line up with the "INSERT" groove.
14
and outlet hose
4
4
for correct seat in the
at the outlet
7
are equipped with
reducer
15
.
8