Removing Groover From 300 Power Drive; Transporting Groover With No. 32 Transport Cart - RIDGID 920 Manual Del Operador

920 Roll Groover
Failure to properly tighten bolt could result in
CAUTION
damage to the groover.
7. Install the matching upper groove roll and shaft.
Grease if necessary through the zerk (grease fitting)
on the upper roll shaft. It may be necessary to lightly
tap the upper roll shaft in place. Make sure to align the
set screw hole on the upper roll housing with the
groove on the upper roll shaft.
Figure 22 – Align Set Screw with Groove On Shaft
8. Tighten the # 1 / - 20 set screw in the upper roll hous-
4
ing until it contacts the upper roll shaft.
9. Tighten the chuck on the 300 Power Drive.

Removing Groover From 300 Power Drive

Because of the heavy weight of the groov-
WARNING
er, two (2) people are needed to lift and remove the unit
from the 300 Power Drive.
1. Using two people, remove the hitch pins holding the
legs in the base sockets (Figure 23). Lift each side of
the groover and remove the legs. Remove pump
handle and set aside.
While the roll groover base is on the pow-
WARNING
er drive without the legs attached, it is front heavy and
could tip over. Push back on the tool head.
14
Figure 23 – Removing Legs From Base
2. Loosen the chuck on the 300 Power Drive. Slide the
groover off the support arms. Place groover on the
ground being sure not to damage the guards.
Transporting the Groover
Use the No. 32 Transport Cart to move the 920 Groover.
WARNING
two (2) people are needed to lift the unit.
1. To attach the transport cart to the groover, insert
the cart into the socket located at the bottom of the
base (Figure 24). Make sure the two alignment lugs
on the cart are also inserted in the base.
Figure 24 – Mounting the Groover to the No. 32
Transport Cart
Ridge Tool Company
Because of heavy weight of the groover,