Alto Professional AX2304 Guia Del Usuario página 6

MONO 4-WAY SETUP
1. Use the included power cable to connect
AX2304 to a wall outlet.
2. Connect the mono source from the mixer's
output to the input connector of Channel 1 on
AX2304.
3. Connect the High Output of AX2304 to the
audio input of your amplifier.
4. Connect the Low Output of AX2304 to the audio input of your system.
5. Connect the Low-Mid Output of AX2304 to the audio input of your amplifier.
6. Connect the High-Mid Output of AX2304 to the audio input of your amplifier.
7. *Adjust the Mode button so that the left button is raised and the right button is depressed. The Mono
LED will light up on the front panel for Channel 1.
8. *Use the Xover Freq button to adjust the control range of the front panel Low/Low-Mid from 44 Hz to
930 Hz or 440 Hz to 9.3 kHz.
9. Power up AX2304 first, then the amplifier to run the system. When powering off, ensure the amplifier is
turned off first, then the AX2304.
*WARNING: Make sure to power off your
speakers before pressing the XOVER FREQ
button and the Mode buttons as a loud burst of
noise will be sent that can damage speakers.
6