Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.
To vary the driving speed, simply increase or
decrease pressure on the lever. The further the
lever is pulled, the greater the speed.
Using the forward/reverse switch
The forward/reverse switch is located on the top, back of
the tool as shown.
1.
For forward (clockwise) rotation, push the
forward/reverse switch up.
2.
For reverse (counterclockwise) rotation, push
the forward/reverse switch down.
Note: To prevent damage to the motor, allow the tool to
come to a complete stop before reversing.
When selecting a bit, use the right type for your job.
Driving Screws
1.
Select the proper style and size 1/4" hex screwdriver bit for the type of screw being used.
2.
Insert the screwdriver bit into the screwdriver.
3.
Insert the screwdriver bit firmly in the head of the screw.
4.
Place the tip of the screw in the pilot hole on the workpiece and squeeze the lever and apply steady and even pressure. At this
point the clutch will engage, driving the screw. Once the screw bottoms out, a ratcheting sound will be heard.
Removing Screws
1.
Reverse the direction of rotation on tool.
2.
Place the bit tip into the screw, squeeze the lever and apply pressure to engage the clutches.
MAINTENANCE
Cleaning Tool
With the motor running, blow dirt and dust out of all air vents with dry air at least once a week. Wear safety glasses when performing this
operation. Keep the tool handles clean, dry, and free of oil or grease by using a mild detergent and a damp cloth to clean your tool.
Although these parts are highly solvent resistant, NEVER use solvents.
Maintaining Tool
Keep your tool in good working condition by adopting a regular maintenance program. Examine the general condition of your tool before
each use. Inspect guards, switches, and extension cord for damage. Check for loose screws, misalignment, binding of moving parts,
improper mounting, broken parts, and any other conditions that may affect its safe operation. If abnormal noise or vibration occurs, turn
the tool off immediately and have the problem corrected before further use. Do not use a damaged tool. Tag damaged tools "DO NOT
USE" until repaired.
Repairing Tool
If your tool is damaged, return the entire tool to the nearest authorized Sioux Tools service center.
ACCESSORIES
Recommended accessories are available at extra cost from you local service center.
CAUTION: The use of any non-recommended accessories may be hazardous.
Double Insulation
Tools marked "Double Insulated" do not require grounding. They have a special double insulation system, which
satisfies OSHA requirements and complies with the applicable standards of Underwriters' Laboratories, Inc., the
Canadian Standards Association and the National Electrical Code. Double Insulated tools may be used in either
of the 120 volt outlets shown in figs. A and B.
FORWARD
REVERSE
3
FORWARD
REVERSE
Tabla de contenido
