Adjusting The Motor Version; Replacing The Batteries Of The Remote Control And The Wall Switch (Accessory) - Dometic PR2000 Instrucciones De Montaje

Operating the awning
Retracting the motor version
1. Press the button
extended by about 1.5 metres. Position the struts vertically and back under the
front panel every 30 cm so that the awning stays secured at all times.
2. Fold the lever of the right strut down to loosen the struts.
3. Slide the struts together completely.
4. Fold the right strut up.
5. Turn the right strut into the front panel.
6. Slide the bottom part of the right strut into the latch of the front panel.
7. Retract the other strut in the same way.
8. Press the button
been completely retracted.
9. Double-check that the awning is fully retracted before starting your journey. The
front panel should be right up against the housing.
A
NOTICE! Beware of damage.
If the awning is retracted when wet, extend it again and let the fabric dry
out at the next opportunity. If the wet fabric stays rolled up for a long
time, mildew will form and the fabric can fade.
7.4

Adjusting the motor version

I
NOTE
The motor is pre-assembled in the roller tube.
If the awning no longer fully closes or opens, adjust the motor (fig. d, page 9 to
fig. g, page 10).
7.5 Replacing the batteries of the remote control and the
wall switch (accessory)
I
NOTE
If the LED of the remote control does not light up after pressing one of
the buttons, the remote control battery is flat.
1. Open the housing (fig. h 1, page 11).
2. Remove the old battery from the holder.
22
of the switch or the remote control until the awning is only
of the switch or the remote control until the awning has
PR2000, PR2500
EN