Porcelanosa Systempool Krion 3-WAY Serie Manual Instalación página 8

3-WAY Series
EN
2.1 RECESSED
4) Place the washbasin over the KRION™ sheet so that the marks on the rim coincide with the axes marked on the sheet.
Fit small centring blocks in place using adhesive, so that it is easier to centre the washbasin.
Make a chamfer to the wood centring blocks to
avoid contact with adhesive.
5) Using a wooden block and 120-grain sandpaper, sand the underside of the KRION™ sheet where the washbasin is to be attached.
6) Sand the upper rim of the washbasin using 120-grain sandpaper.
120-grain sandpaper
7) Clean the connecting points with denatured alcohol.
8) Apply seam adhesive to the sheet, completely covering the rim. Adhesive
9) Place the washbasin over the sheet, making sure that the washbasin is correctly centred with the wooden blocks.
10) Pass the threaded bar through the drain and hole in the sheet. Fit the washers for applying pressure on the upper surface of the
sheet and bottom surface of the washbasin. Then start to screw in the two wing nuts from each end until the sheet and washbasin are
held firmly in place.
Pág. 2/6