Surface Installation - Dimplex BLF50-EU Manual Del Propietário

Fireplace Installation
the fireplace is packaged with
a three prong plug installed for
plug-in convenience. Hard wiring
the fireplace is also an option
by removing the plug from the
factory fitted cord and completing
the wiring according to national
and Local Elecrical Codes.
WARNINg: Do not attempt to
wire your own new outlets or
circuits. to reduce the risk of
fire, electric shock or injury to
persons, always use a licensed
electrician.
WARNINg: Ensure that the
3-Position switch is set to the
off position ("o") and that the
circuit on which the fireplace is
to be installed has the power
cut off at the service panel until
installation is complete.

Surface Installation

CAUTION: Two people may
be required for various steps
of this procedure.
1. Choose a location for
mounting the unit.
2. Choose your method of
supplying power to the unit:
• Plug in to an existing outlet
or install an outlet nearby.
• Hard wire the fireplace.
8
Figure 2
Glass Bracket
!
NOTE: Hard wiring can
be done by removing the plug
from the factory fitted cord and
completing the wiring according
to national and Local Elecrical
Codes.
WARNINg: Do not attempt
to wire your own new outlets or
circuits. to reduce the risk of fire,
electric shock or injury to persons,
always use a licensed electrician.
Ensure that the 3-Position switch is
set to the off position ("o") and that
the circuit on which the fireplace is
to be installed has the power cut off
at the service panel until installation
is complete.
3. Remove the partially
reflective glass from the
fireplace:
Bracket screws
Partially
reflective Glass
www.dimplex.de