Fireplace Installation; Site Selection - Dimplex BLF50-EU Manual Del Propietário

Fireplace Installation

Site Selection

review and consider all of the
following conditions for installation:
• Dimensions of the unit: 128cm
x 49.5cm
• Unit requires a minimum of two
(2) wall studs in order to ensure
a secure installation
Three possible installation
methods:
• Installation method: surface
mount; In-wall recessed; or
Flush mount
• Hardwired or plug-in method
WARNINg: Ensure the power
cord is not installed so that it
is pinched or against a sharp
edge and ensure that the
power cord is stored or secured
to avoid tripping or snagging to
reduce the risk of fire, electric
shock or injury to persons.
Construction and electrical
outlet wiring must comply
with local building codes and
other applicable regulations to
reduce the risk of fire, electric
shock and injury to persons.
1. select a location that is not
susceptible to moisture and
is away from drapes, furniture
and high traffic.
2. For ease of electrical
hook up you may wish to
locate the fireplace near an
existing outlet (for plug-in
convenience).
!
NOTE 1: A 13 Amp, 230 Volt
circuit is required. A dedicated
circuit is preferred but not
essential in all cases. A
dedicated circuit will be
required if, after installation,
the circuit breaker trips or
fuse blows on a regular basis
when the heater is operating.
Additional appliances on the
same circuit may exceed the
current rating of the circuit
breaker.
3. remove fireplace, front
glass and hardware from box
and remove all packaging
materials before installation.
4. store the fireplace in a safe,
dry and dust free location until
you are ready to install the
fireplace.
7