Printed Wiring Boards -Cd Section - Sony CDX-MP30 Manual De Servicio

CDX-MP30
THIS NOTE IS COMMON FOR PRINTED WIRING
BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is
printed in each block.)
for schematic diagram:
• All capacitors are in µF unless otherwise noted. pF: µµF
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in Ω and
1 / W or less unless otherwise
4
specified.
• % : indicates tolerance.
• f : internal component.
• C : panel designation.
Note: The components identified by mark 0 or dotted line
with mark 0 are critical for safety.
Replace only with part number specified.
• A : B+ Line.
• Power voltage is dc 14.4V and fed with regulated dc power
supply from ACC and BATT cords.
• Voltages are taken with a VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F : FM
f
: AM(MW/LW)
J
: CD
c : CD-R/RW(MP3)
for printed wiring boards:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
• : parts mounted on the conductor side.
x
• : Through hole.
a
• : Pattern from the side which enables seeing.
(The other layer's patterns are not indicated.)
Caution:
Pattern face side: Parts on the pattern face side seen from the
(Side B) pattern face are indicated.
Parts face side: Parts on the parts face side seen from the
(Side A) parts face are indicated.
3-4. Printed Wiring Boards –CD Section– • Refer to page 15 for Circuit Boards Location.
• Semiconductor
Location
Ref. No. Location
IC6 B-4
IC12 B-3
Q1 A-1
16 16
C78
C77
FB6
IC6
IC12