Scope Of Delivery; Technical Data - Parkside PABS 18-Li B2 Instrucciones De Utilización Y De Seguridad

Rechargeable battery pack
6
Battery pack release button
7
LED light button
8
LED light
9
Rechargeable battery display LED
10
Rechargeable battery charge state button
11
LED working light
12
Drill chuck
13
Torque pre-selector
14
Fast charger
15
Red charge-control LED
16
Green charge-control LED
17

Scope of delivery

Q
1 Cordless drill with rechargeable battery pack
1 Bit PH2 50 mm
1 Fast charger
1 Carry case
1 Directions for use

Technical Data

Q
PABS 18-Li B2 Cordless drill:
Nominal voltage:
Idle-running speed:
Idle-running speed:
Drill chuck
clamping range:
Maximum
drill diameter:
Max. torque:
PABS 18-Li B2-1 Battery Pack:
Type:
Nominal voltage:
Capacity:
Energy content:
PABS 18-Li B2-2 Fast Charger:
INPUT
Nominal voltage:
Power input:
Introduction / General safety advice for electrical power tools
18 V
1st gear: max. 400 min
2nd gear: max. 1400 min
max. 10 mm
Steel: 10 mm,
Wood: 30 mm
35 Nm
LITHIUM-IoN
18 V
1.5 Ah
27 Wh
230 V∼, 50 Hz
55 W
OUTPUT
Nominal voltage:
Charging current
Charging time:
Protection class:
Noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level: 76 dB(A)
Sound power level:
Uncertainty K:
Total vibration (vector sum of three directions) is
calculated in accordance with EN 60745:
Screwing:
Drilling:
these instructions was measured in accordance with
an EN 60745 standardised measurement process
-1 and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
-1
preliminary assessment of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool an in some cases may
exceed the value specified in these instructions. Re-
gularly using the electric tool in such a way may
make it easy to underestimate the vibration.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
18 V
2 A
approx. 60 min
II /
87 dB(A)
3 dB
Vibration emission value
a = 0.865 m / s ,
2
h,D
uncertainty K = 1.5 m / s
Vibration emission value
a = 2.546 m / s ,
2
h
uncertainty K = 1.5 m / s
The vibration level specified in
GB/MT
,
2
.
2
43