Tabla de contenido
Idiomas disponibles
Idiomas disponibles
the NVR has loaded. The wizard walks you
through some of the more important
settings of your NVR. Select the preferred
language for the system and then enter the
administrator password. The default admin
password is 1234. It is strongly
recommended that this password is
changed.
The wizard will then guide you through the
menus to set the time and date, network
configuration, HDD management, and
recording configuration.
When all the required changes have been
entered, click
Finish
NVR 50 is now ready to use. Recording
starts automatically.
Operating the TVN 50
There are several ways to control the unit:
•
Front panel
•
IR remote control
•
Mouse
•
Web browser
Front panel
The buttons on the front panel control most
functions. See Figure 2 on page 2 for the
locations of the controls.
IR remote control
The IR remote control buttons are similar to
those on the front panel. Place the two AAA
batteries in the remote control.
To connect the remote control to the
NVR:
1. Press
Menu
on the front panel or right-
click the mouse and select Menu. The
main menu screen appears.
2. Select
Display mode settings
Monitor.
3. Check and remember NVR device
address value. The default value is 255.
The device address is valid for all IR
controls.
EN : 4
to exit the wizard. The
>
4. On the remote control press the
button.
5. Enter the device address value. It must
be the same as that on the TVN 50.
6. Press
ENTER
on the remote or front
panel.
USB mouse
The USB mouse provided with the TVN 50
operates all the functions of the NVR, unlike
the front panel, which has limited
functionality. The mouse lets you navigate
and make changes to settings in the user
interface.
Connect the mouse to the NVR by plugging
the mouse USB connector into the USB
port on the front panel. The mouse is
immediately operational and the pointer
should appear.
Web browser control
The TVN 50 Web browser lets you view,
record, and play back videos as well as
manage all aspects of the NVR from any
PC with Internet access. The browser's
easy-to-use controls give you quick access
to all NVR functions. See Figure 3 on page 5.
To access the unit, open a web browser
and enter the IP address assigned to the
NVR as a Web address. In the login screen,
enter the default user ID and password:
•
User ID: admin
•
Password: 1234
The default values for TVN 50 network
settings are:
•
DHCP: Enabled by default.
•
IP address - 192.168.1.82
•
Subnet mask - 255.255.255.0
•
Gateway address - 192.168.1.1
•
Ports:
When using the browser:
RTSP port: 554
HTTP port: 80
TVN 50 Quick Start Guide
Device
Tabla de contenido
