Installation; Operating Limits - Carrier Aqua SNAP PLUS 30AW Manual Del Usuario

Installation

Before installation, check strength and horizontality of the
base so that abnormal sound does not generate.
According to the dimensions and clearances, fix the base
firmly with the anchor bolts (Anchor bolt, nut: M10 x 2
pairs).
Opening cable knockouts
There is a pre-cut part that can be removed for running
wires.
Do not remove the unit front panel for easier drilling of the
knockouts. The pre-cut section of the sheet can be removed
by punching the 3 connection points along the line first
using a screwdriver and finally with your hands (See Fig. 4).
How to remove the front panel
1. Remove screws of the front panel (See fig. 5).
Drain hose and base pan knockouts
See fig. 6.
In case of draining through the drain hose, attach the drain
nipple (A) and use the drain hose (Inner diam.: 16mm) sold
on the market. When there is a possibility of freezing of
drain at the cold district or a snowfall area, be careful for
drainage ability of drain.

Operating limits

Operation in cooling
See fig. 7
A- Outdoor air temperature (°C)
B- Outlet water temperature (°C)
Note: For the 30AWH006_ unit use a minimum External Air
Temperature of +5 °C.
If the outdoor unit is installed in a very windy place, protect
the fan with a wind protection screen and check that it
works correctly.
When the cable knockout is open, remove the burrs and fit
the cable protective bush supplied with the unit for cable
protection.
2. Pull the front panel downward with the handle.
The drainage ability increases when knockout holes on the
base pan are opened. (Open the knockout hole to outside
using a hammer (B), etc.).
Operation in heating
See fig. 8
A- Outdoor air temperature (°C)
B- Outlet water temperature (°C)
(Fig. 4)
(Fig. 5)
(Fig. 6)
(Fig. 7/8)
30AW 5