Cable Gland Assembly - V2 FLEXY2 Manual De Instrucciones

A1 Antenna
A2 Antenna shield
L1 Opening command for a standard connection device
with switch normally open.
L2 Pedestrian opening command for a standard
connection device with switch normally open.
L3 STOP command. N.C. switch
L4 Photocell. N.C. switch
L5 Edge. Switch N.C. or resistive rubber edge
L6
Limit switch open. N.C. switch
L7
Limit switch closed. N.C. switch
L8
Commands common (-) line
L9 - L10 24 VAC power output for photocells and other
accessories
L10 - L11 Power supply for functional test TX photocell
K1 - K2 Courtesy light timer activation switch
K3 Motor 1 open
K4
Motor 1 common
K5
Motor 1 close
K6
Motor 2 open
K7 Motor 2 common
K8 Motor 2 closed
K9 - K10 230V - 40W / 120V - 40W blinker
N 230V / 120V power supply - neutral
L
230V / 120V power supply - phase

CABLE GLAND ASSEMBLY

The casing can accept 4 cable glands in the special easy-break
housings.
The type of cable gland is indicated in the figure.
m
PLEASE NOTE:
• Remove the electronic circuit board before drill the casing.
• Drill the container using a suitably sized cutter, according to the
dimensions of the cable gland.
• Fix the cable glands using the special nuts.
PG9 - PG11
PG9 - PG11 - PG16
- 13 -