General Characteristics - CAME Z Serie Manual Del Usuario

ENGLISH
Description of control board
The ZA3 electric board is suitable for
controlling the automation of ATI,
FERNI and FROG series 230V swing
gates with up to 600W power and 50-
60Hz frequency.
Wholly designed and built by CAME
S.p.A., it meets UNI 8612 regulations
in force. The board is inserted and
fixed to the ABS case (S4339 o
S4340), which has an IP54 protection
level, with air recycling inlet and
transformer.
The board requires 230V (a.c.) at
terminal blocks L1-L2 and the inlet is
protected with two 5A fuses. A 3.15A
fuse protects the low voltage command
devices.
The accessories' total wattage (24V)
must not exceed 20W.
Photocells can be connected to
obtain:
- Re-opening during closure (2-C1), if
the photocells identify an obstacle
while the gate is closing, they will
reverse the direction of movement until
the gate is completely open;
- Re-closing during opening (2-CX, dip
-4-

GENERAL CHARACTERISTICS

Safety
8OFF-10OFF), if the photocells identify
an obstacle while the gate is opening,
they will reverse the direction of
movement until the gate is completely
closed;
- Partial stop, shutdown of moving
gate, with activation of an automatic
closing cycle (2-CX);
- Total stop (1-2), shutdown of gate
movement without automatic closing; a
pushbutton or radio remote control
must be actuated to resume
movement).
NB: If an NC safety contact (2-C1, 2-
CX, 1-2) is opened, the LED will flash
to indicate this fact.
Accessories which can be
connected to this unit
- "Gate open" signal ligh t (10-5);
- Cycle lamp. The lamp which lights the
manoeuvring zone: it remains lit from
the moment the doors begin to open
until they are completely closed
(including the time required for the
automatic closure). In case automatic
closure is not enabled, the lamp
remains lit only during movement (E-
E3);
- Electric lock (11-S);