Samsung WA52J8060A Serie Manual Del Usuario página 54

Troubleshooting
Fills with the wrong
temperature water.
o
Door (Lid) locked or
will not open
o
o
o
o
Does not drain and/
o
o
o
o
o
Load is wet at the end
o
of the cycle.
o
• Fully open both water taps.
• Make sure the temperature selection is correct.
• Make sure the hoses are connected to the correct water taps.
Flush water lines.
• Disconnect the hoses and clean the screens. The hose filter
screens may be clogged.
• While the washing machine fills, the water temperature may
change as the automatic temperature control feature checks
incoming water temperature. This is normal.
• While the washing machine fills, you may notice just hot and/
or just cold water going through the dispenser when cold or
warm temperatures are selected.
This is a normal function of the automatic temperature
control feature as the washing machine determines the water
temperature.
While the washing machine is operating, press or tap Start/
Pause to stop the washing machine.
It may take a few moments for the door lock mechanism to
disengage.
Check the fuse or reset the circuit breaker.
Make sure the electrical voltage is normal.
Make sure the washing machine is plugged in.
Make sure the drain hose is pointed downward. (Natural drain
models only)
Make sure the drain hose is not clogged.
Make sure the drain hose is not kinked.
Straighten the drain hose. If there is a drain restriction, call for
service.
Close the door, and press or tap Start/Pause. For your safety,
the washing machine will not spin unless the door is closed.
Use the High or Extra High spin speed. (Applicable model
only)
Use high efficiency (HE) detergent to reduce oversudsing.
Load is too small. Small loads (one or two items) may become
unbalanced and not spin completely.
54 English
\\TAg000J \\TAg700J "_\TA52J 03133Y 01 ENindd 54 2015/4/20 15:33:55