Operating Your Humidifier - Vicks VEV320 Serie Manual De Uso Y Cuidado

VEV320 Series Accessories
The following accessories work great with your humidifier.
Required Vicks VapoPads
®
Protec Extended Provides soothing
Life Humidifier Filter menthol (VSP-19,
(PWF2/PWF2-CAN) VSP19FP, VSP-19-CAN,
VSP19VPC) or lavender/
Removes minerals
rosemary (VBR-5, US
and pollutants
only) vapors.
from water. Helps
prevent the growth (One Menthol Sample
Pad Included)
& migration of mold,
algae and bacteria
on filter.
Setting Up Your Humidifier
Step 1 Step 2
1.
Remove packaging material. Keep this Use and Care Manual for future reference.
2.
Remove twist tie and extend power cord.
3.
Place the humidifier on a firm, level, water resistant surface at least 12" (30 cm) from any
walls. DO NOT block Intake Grill on base of unit. DO NOT place on surfaces that can be
damaged by water.
Prepare Wicking Filter
A Wicking Filter is required for this unit to operate.
The Wicking Filter will capture minerals from your water and will prevent "white dust."
If you have hard water, you will need to replace your filter more frequently.
See "Filter Care " section for tips on prolonging the life of your Wicking Filter.
4
Protec Antimicrobial Humidity Monitor
®
Cleaning Cartridge (V70 or V70-CAN)
(PC-1, PC-2 and
Displays relative
PC-1C)
humidity and room
Helps keep your temperature so
humidifier cleaner, you can maintain a
longer. Continuously comfortable humidity
cleans and protects level in your home.
humidifiers against The ideal humidity
bacteria & mold. level is between
40-60%.
Step 3
Prepare Wicking Filter
Step 1 Step 2
1.
Lift Motor Housing.
2.
Run Wicking Filter under cool water until saturated.
3.
Gently place wet Wicking Filter in base; do not squeeze out excess water.
Filling/Refilling Water Tank
Step 2 Step 3
Step 1
1.
Remove the Water Tank and carry to sink or tub. Turn Tank upside down and remove the Tank
Cap by turning counter-clockwise (left). You can grasp the outside of the Tank Cap or the inside
support ribs, whichever is more comfortable for you.
2.
Fill the Water Tank with cool tap water. Do not use warm or hot water. The Tank and Reservoir
combined hold approximately 0.8 gallons (3.0 L) of water.
Note: The top of the Water Tank is flat so it should sit flat in your sink. If it does not fit, the large
Tank opening will allow you to tip the Tank sideways to fill.
3.
Replace Tank Cap and secure tightly by turning clockwise (to right).
4.
Carry full Water Tank back to humidifier using two hands; one hand on handle at the top of the
Tank and other hand supporting the bottom of the Tank. Take care not to push the plunger on
the bottom of the Water Tank or leaking may occur.
5.
Place the Water Tank on the humidifier Base. You will hear the water draining into the Reservoir.

Operating Your Humidifier

Step 1 Step 2
1.
With Power Knob in the OFF position, plug humidifier into a polarized 120V outlet.
CAUTION: To avoid electric shock, do not plug humidifier into outlet with wet hands.
(Continued)
Step 3
$
Step 4
Step 5
Step 3

5