Wireless > Wireless Mac Filter - Cisco LINKSYS Wireless-N WRT120N Manual Del Usuario

Chapter 3
WEP
WEP is a basic encryption method, which is not as secure
as WPA.
IMPORTANT:
If you are using WEP encryption,
then each device in your wireless network MUST
use the same WEP encryption method and key,
or else the network will not function properly.
Security Mode > WEP
Encryption Select a level
40/64 bits (10 hex digits) or 104/128 bits (26 hex digits).
The default is 40/64 bits (10 hex digits).
Passphrase
Enter a Passphrase to automatically generate
WEP keys. Then click Generate.
Key 1 If you did not enter a Passphrase, enter the WEP
key manually.
TX Key
TX (Transmit) Key 1 is used.
Click Save Settings to apply your changes, or click Cancel
Changes to clear your changes.
Wireless-N Home Router
of WEP encryption,
Advanced Configuration
Wireless > Wireless MAC Filter
Wireless access can be filtered by using the MAC addresses of
the wireless devices transmitting within your network's radius.
Wireless > Wireless MAC Filter
Wireless MAC Filter
Enabled/Disabled
To filter wireless users by MAC Address,
either permitting or blocking access, select Enabled. If you
do not wish to filter users by MAC Address, keep the default,
Disabled.
Access Restriction
Prevent
Select this option to block wireless access by
MAC Address. This button is selected by default.
Permit Select this option to allow wireless access by MAC
Address. This button is not selected by default.
MAC Address Filter List
Wireless Client List Click this button to open the Wireless
Client List screen.
14