Tabla de contenido
Idiomas disponibles
Idiomas disponibles
HOW TO USE YOUR PRESSURE
WASHER
If you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-222-3136.
To Start Your Pressure
Washer
To start your engine-powered
pressure washer for the
first time, follow these instructions step-by-step. This
starting information also applies whenever you start
the engine after you have let the pressure washer sit
idle for at least a day.
•
Place the pressure washer in an area close
enough to an outside water source capable of
supplying water at a flow rate greater than
2.2 gallons per minute.
•
Check that the high pressure hose is tightly
connected to the spray gun and to the pump. See
"Assembling Your Pressure Washer" for
illustrations.
•
Make sure unit is in a level position.
•
Connect the garden hose to the water inlet on the
pressure washer pump. Turn ON the water.
A
AUTION:
Do Not run the pump without the
water supply connected and turned on. You
must follow this caution or the pump will be
damaged.
•
Rotate the choke knob to the "Choke" position.
Right Hand
pulls recoil
starter handle
\
Left
holds base
Safety Goggles
Left Hand
squeezes trigger
and steadies
upper part of unit
Do Not
attach
nozzle
extension
l
NOTE: For a warm engine, be sure the choke knob is
in the "Run" position.
Move the throttle lever to "Fast" position, shown on
unit as a rabbit.
•
As shown at the right, ensure the nozzle extension
is NOT attached to the spray gun.
•
Place your left foot on the unit's lower frame.
•
Grasp the spray gun with your left hand and
squeeze the trigger on the spray gun. Water will
flow out of the spray gun in a thin stream. Continue
to squeeze the trigger. Your left hand will also
serve to steady the unit.
•
Grasp the recoil starter handle with your right hand,
as shown. Pull the starter handle lightly until you
feel some resistance, then pull briskly. Return the
starter grip handle slowly. Do Not let rope "snap
back" against starter.
•
When engine starts, release the spray gun trigger
and slowly rotate choke knob to the "Run" position
as engine warms and runs smoothly.
•
Engage the safety latch to the spray gun trigger.
Safety Latch
Tabla de contenido
