Troubleshooting - Worx WG300E Manual Del Usuario

TROUBLESHOOTInG

Symptom
Chain saw fails to
operate
Chain saw operates
intermittently
Dry chain
Kickback Brake / Run
down brake
Chain/chain bar
overheats
Chain saw rips, vibrates,
does not saw properly
Never use tools with defective On/Off switches or defective Kickback brake (Hand Guard).
In the case of all other types of technical faults, please contact helpline or local service center.
Chain saw
Possible
Kickback brake is activated
No power
Mains socket faulty
Extension cord damaged
Fuse faulty
Extension cord damaged
Loose connection
Internal wiring defective
On/Off switch defective
No oil in reservoir
Vent in oil filler cap clogged
Oil passage clogged
Brake does not stop chain
No oil in reservoir
Vent in oil filler cap clogged
Oil passage clogged
Chain is over tensioned
Dull chain
Chain tension too loose
Dull chain
Chain worn out
Chain teeth are facing in the
wrong direction
Cause
Pull hand guard back in position
(Figure G)
Check power
Use another socket
Check cord, replace
Replace fuse
Check cord, replace
Contact service agent
Contact service agent
Contact service agent
Refill oil
Clean cap
Clean oil passage outlet
Contact service agent
Refill oil
Clean cap
Clean oil passage outlet
Adjust locking knob
Sharpen chain or replace
Adjust locking knob
Sharpen chain or replace
Replace chain
Reassemble with chain in correct
direction
19 19
En