Program Selection - MACHEREY-NAGEL NANOCOLOR VARIO Mini Manual De Instrucciones

5.3 Program selection

Repeated pushing of the
possible to enter user defined temperatures.
Repeated pushing of the
possible to enter user defined heating times.
The selected program is started via the
displayed temperature blinks. The current temperature of the block can be displayed via
the button. When the set temperature is reached, the displayed temperature stops
blinking and the countdown is started automatically.
!
The heating block might get hot during the heating process, especially at the
bottom side and inside the boreholes for the tubes. Therefore, do not hold the
heating block in your hand during the heating process and do not touch the in-
side of the bore holes. Wait for at least 10 minutes after the heating process is finished
until you move the heating block.
A running program can be stopped at any time by pushing the
"STOP" appears in the display instead of the heating time. To end the program, the
button has to be pushed once more within 5 seconds. If this does not happen, the
program continues.
By pushing one of the following buttons (
up. It can be started via the
display goes back to the menu for program selection.
key calls up the preprogrammed temperatures. It is not
key calls up the preprogrammed heating times. It is not
button. If the program is not started within 5 seconds, the
NANOCOLOR VARIO Mini V 1.0 / 01.16
®
button. During the heating process the
, , ), the program last used is called
button. A blinking
27