Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Cleaning the shaver
1
1
Insert the appliance plug.
2
2
Plug in the adaptor.
•
Remove any soap or water on the shaver if
it has been washed with hand soap or any
other detergent.
3
3
Remove the protective cap
and then attach the shaver.
•
Turn the shaver off before attaching.
•
Check that the outer foil is not deformed or
damaged when you are attaching the
shaver.
4
4
Press [SELECT] to select the
course.
•
The "Charge" course starts when attaching
the shaver.
•
Each time you press [SELECT], the course
changes from "Clean/Dry/Charge"
Charge"
"Charge".
•
The courses start approximately 6 seconds after they are
selected.
•
The course will be aborted if the power is cut off. In this case,
perform the course again from the beginning.
•
Do not detach the detergent cartridge or the water tank as the
cleaning liquid may spill causing a malfunction.
8
2
1
3
"Dry/
Course
Course
selection
indications
Charge
Clean/Dry/
Charge
Dry/Charge
Time required (guide)
[In the low
temperature]
Charge (0 to 60 min)
Clean (10 min)
Dry (80 min [170 min])
Charge (0 to 60 min)
Dry (180 min)
Charge (0 to 60 min)
Tabla de contenido
