General Specifications - Klein Tools KTB5 Manual Del Usuario

ENGLISH
The Klein Tools KTB5 is a portable battery pack with the ability to supply 300W of pure sine wave AC power via the two on-board AC outlets. Additionally, the battery pack is able to support
USB quick charging via the on-board USB-C ports, and standard USB-A ports. Overall storage capacity is 546Wh of energy.
• Capacity: 546Wh (24.8Ah / 22.02V)
• Cell Type: 18650
• Cell Chemistry: Li-Ion
• Input: 8mm round port 25.2V DC / 3.5A
• AC Output: 120V each plug, 300W shared / 600W peak
• USB Output (total output 30W): USB-A: 2 x 5V 2.4A, USB-C: 2 x 5V 3.0A
• Operating / Storage Altitude: 6562 ft. (2000m)
• Operating / Storage Maximum Humidity: <75% non-condensing
• Operating Temp: 14° to 104°F (-10° to 40°C)
• Charging Temp: 32° to 104°F (0° to 40°C)
• Storage Temp: -4° to 113°F (-20° to 45°C)
• Dimensions: 7.25" x 11.75" x 7.5" (184 x 298 x 191mm)
• Weight: 14.8 lbs (6.71 kg)
• Life Expectancy: 500 cycles to 70% capacity typical (depending on use and care)
• Standards: UL1642,
IEC/EN60950-1, IEC/EN6065,
IEC62133, IEC60086-4, IEC62281,
UN38.3
• Charging Time: Full charge 8 to 10 hours
• Shelf Life: Charge every 3 months (fully charge before storage)
• Transportation: This unit complies with all legal requirements for transport of dangerous goods. The capacity of the lithium battery pack exceeds 100Wh. Based on
international standards, if this unit is transported by airplane, it must be transported in accordance with IATA standard packaging. IATA instructions and labeling
requirements and the relevant declarations must be completed.
Specifications subject to change.
To ensure safe operation and service of the meter, follow these instructions. Failure to observe these warnings can result in severe injury or death.
• Do NOT use portable battery in excess of its output rating. Overload outputs above rating may result in a risk of fire or injury to persons.
• Use of a power supply, charger, or cable not recommended or sold by portable battery manufacturer may result in a risk of fire or injury to persons.
• Do NOT use portable battery or AC wall charger, if it is damaged or has been modified. Damaged or modified batteries may exhibit unpredictable behavior resulting in fire,
explosion, or risk of injury.
• Do NOT subject to vibration, impacts, or drops. Secure the unit during transport. The housing may not show signs of damage, but internal components may have been
compromised. It is adviseable to replace the unit if any such severe events occur.
• Do NOT expose portable battery to moisture, rain, or snow.
• Keep away from high voltage electrical fields.
• Do NOT attempt to repair portable battery or AC wall charger. There are no user-serviceable components inside.
• Risk of fire and burns, do not open, crush, heat above 140F (60C) or incinerate. Follow all instructions.
• NOT intended for use with plug types or adapters not listed on the product label.
• Do NOT handle unit with wet hands.
• Do NOT place the unit on its side or upside down while in use or in storage.
• If rust, odor, overheating, or other abnormal circumstance are observed, stop using and contact Klein Tools customer service.
FCC & IC COMPLIANCE
This device complies with part 15 of the FCC RULES and Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
NOTE: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the user's
authority to operate the equipment.
IC NOTICE TO CANADIAN USERS
This device complies with industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference that may cause undesired operation of the device.
This device complies with RSS-247 of Industry Canada. Operation is subject to the condition that this device does not cause harmful interference. This Class B digital apparatus
complies with Canadian ICES-003.
2

GENERAL SPECIFICATIONS

WARNINGS
COMPLIANCE