Assembly And Operation; Environmental Protection - Worx WX427 Manual De Instrucciones

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The tool is intended for ripping and cross-cutting
wood and other materials in straight cutting
lines, while resting firmly on the work piece.

ASSEMBLY AND OPERATION

Action
Saw Blade Assembly And
Removing
Safety On/Off Switch
Cross And Rip Cutting
Using The Laser Light
Feature
Replacing Laser Batteries
Parallel Guide
Cutting Depth Adjusting
Cutting Angle Adjusting
Pocket Cutting
Sawdust Removal
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please
run your circular saw no load for 2-3 minutes
to cool the motor. Avoid prolonged usage at
very low speeds.
Protect saw blades against impact and shock.
Cutting with extreme force can significantly
reduces the performance capability of the tool
and reduces the service life of the saw blade.
Sawing performance and cutting quality
depend essentially on the condition and the
tooth count of the saw blade. Therefore, use
only sharp saw blades that are suited for the
material being cut.
Choice of blades: 24 teeth for general work,
approx. 40 teeth for finer cuts, more than 40
teeth for very fine cuts into delicate surfaces,
diamond for tile, cement board, etc.
Only use saw blades recommended.
Electric Circular Saw
MAINTAIN TOOLS WITH
CARE
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
Keep tools sharp and clean for better and
safer performance. Follow instructions for
lubricating and changing accessories. Inspect
tool cords periodically and if damaged, have
repaired by authorized service facility. Your
power tool requires no additional lubrication
or maintenance. There are no user serviceable
parts in your power tool. Never use water or
Figure
chemical cleaners to clean your power tool.
Wipe clean with a dry cloth. Always store
See Fig. A
your power tool in a dry place. Keep the
motor ventilation slots clean. Keep all working
See Fig. B
controls free of dust.
If the supply cord is damaged, it must be
See Fig. C1, C2
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
See Fig. D1, D2
avoid a hazard.
Periodically clear dust and chips from guard
See Fig. E1-E3
and base to ensure proper performance.
See Fig. F1, F2
See Fig. G1, G2
ENVIRONMENTAL
See Fig. H
PROTECTION
See Fig. I1, I2
See Fig. J
Check with your local authorities or retailer for
recycling advice.
Waste electrical products must not be
disposed of with household waste.
Please recycle where facilities exist.
17
EN