Safety Information - Axis T8125 Guia De Instalacion

AXIS T8125 AC 24 V Midspan 60 W
AXIS T8125 AC 24 V Midspan 60 W

Safety Information

AC Power inlet set:
• The power connector supplied with the AXIS T8125 has 2
terminals. See Figure 2.
• The power inlet cables must be rated for a minimum current
capacity of 6 amps (12 AWG for each terminal or 2X16 AWG for
each terminal).
• Before connecting power inlet cables to the connector terminals,
verify that the power source is turned OFF.
• Only for improved EMI performance, connect chassis ground
connection to "Earth Ground" connection at the working area.
Note:
There is no safety hazard when the chassis ground
connection is not connected to the "Earth Ground".
• The 24 V AC power source must be near the AXIS T8125 and easily
accessible. To remove AC power from the AXIS T8125, disconnect
the 24 V AC power inlet from either the 24 V AC power source or
the AXIS T8125 power connector.
• The AXIS T8125 DATA IN and DATA & POWER OUT interfaces are
qualified as SELV (Safety Extra-Low Voltage) circuits according to
IEC 60950-1. These interfaces can only be connected to SELV
interfaces on other equipment.
Note:
The AXIS T8125 "DATA IN" and "DATA & POWER OUT" ports
are shielded RJ45 data sockets. They cannot be used as
Plain Old Telephone Service (POTS) sockets. Only RJ45 data
connectors may be connected to these sockets.
Installation Guide
Page 7