Configuration - SOMFY animeo IB+ 4 Zone Guia De Instalacion

EN
Before installation, please read and follow these instructions. Incorrect installation may lead to serious injury. The
product must be installed by a qualified electrician. SOMFY cannot accept any liability for defects and damage caused
by failure to follow these instructions. Please keep these instructions for future reference.
A
ILLUSTRATIONS
[1] animeo IB+ 4 Zone/8 Zone Touch Building Controller (Ref. 1860254/1860255).
[2] animeo IB+ Flush Mounting Box (Ref. 9019837) - mandatory.
[3] Styroform block to prevent dirt getting inside the animeo IB+ Flush Mounting Box mechanism; it comes with the
animeo IB+ Flush Mounting Box.
[4] animeo IB+ Surface Mounting Box (Ref. 9019838) - optional.
B
FITTING
Choose the optimal location: a large, flat surface.
[1] Fit the Touch Building Controller into a wall using the animeo IB+ Flush Mounting Box.
[2] Fit the Touch Building Controller into a cavity wall or into an electric cabinet door, using the animeo IB+ Flush Mount-
ing Box.
[3] Mount the Touch Building Controller on a wall, using the IB+ Surface Mounting Box.
[4] Remove the Touch Building Controller.
Use the styroform block to prevent damage or dirt getting inside the IB+ Flush Mounting Box mechanism.
• Minimum distance between the Touch Building Controller and Motor Controller with a radio card: 50 mm
• Minimum distance between the IP cable and Motor Controller with a radio card: 50 mm
• No wall between remote control and the Motor Controller with a radio card in an electric cabinet
• Use the shortest possible IB+ cable
C
WIRING
[1] Wiring diagram for the IB+ Touch Building Controller with Outside Sensor Box and Inside Sensor Box.
[2] Alternative wiring diagram for the IB+ Touch Building Controller with Compact Sensor and Inside Sensor Box.
For further details regarding connection and sensors please refer to the corresponding device manual.
Connection to mains outside the IB+ Flush Mounting Box or use a shielded connector!
D

CONFIGURATION

The commissioning of the IB+ Touch Building Controller is completely software-guided. Follow the steps and, if help is
needed, please see the "i" icon in the upper right corner of the display.
For software updates, please use the USB port on the rear of the IB+ Touch Building Controller (use only
USB flash drive with 2 GB at least).
The battery included in the product is designed to last throughout the product's lifetime and is not intended to be replaced.
The following instructions to remove and dispose of the battery properly at the end of product life-cycle are for qualified
electricians only:
• Switch off power-supply and dismantle product
• Undo screws and remove cover
• Remove empty battery and dispose of it correctly (battery type: CR 2032)
Batteries or accumulators have to be separated from other types of waste and must be recycled using your local recycling
facility.
animeo IB+ 4/8 ZONE TOUCH BUILDING CONTROLLER . REF. 5124490 B -
11/32