Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
WARNING
The return spring can jump out - Risk of
injury!
Lever out the cable from the handle
N
using a screwdriver
Remove remainders of the roller
N
and starter rope
5
7
Pull new starter rope downwards
N
from above through the handle and
the rope socket (5)
Pull the starter trope through the
N
pulley (6) and secure it in the pulley
by a simple knot
Wet the bearing bore of the pulley
N
with resin-free oil
Insert pulley on the axle (7) - rotate
N
a little on either side until the lug of
the return spring engages
48
2
4
Insert clips (4) in the pulley again
N
and set the plate (3) on the axle.
Press the spring clap (2) using a
N
screwdriver or suitable pliers on the
axle and over the stud of the clip --
the spring clap must point in the
clockwise direction - as shown in the
figure
Clamp the return spring
6
Form a loop with a unwound starter
N
rope and use it to rotate the pulley
by six turns in the direction of the
arrow
Hold the pulley fast - pull out the
N
twisted rope and arrange it properly
Release the pulley
N
Release the starter rope slowly so
N
that it coils itself on the pulley
The starter handle must be pulled firmly
into the rope socket. If it tilts sideways:
Tighten the spring by another turn.
3
With fully tightened rope, it should ne
4
possible to turn the rope pulley further by
half a turn. If that is not possible, the
spring is too tightly tensioned - Danger
of breaking!
N
N
N
Replace the broken return spring
N
The broken spring pieces can still have
residual tension and could spring back
to your surprise when removing from the
fan housing - Risk of injury! Wear face
shield and protective hand gloves.
N
N
Reduce one rope turn from the
pulley.
Mount the fan housing on the
crankcase
Set the combo lever on the stop
setting 0 and press the remaining
rope into the handle - until the nipple
closes with the handle
Dismantle the cable pulley
WARNING
Lever out broken spring pieces
carefully using a screwdriver.
Wet replacement spring with a few
drops of resin-free oil.
MS 461 R
Capítulos
Tabla de contenido
