Tensioning The Chain - Stihl MS 461 R Manual De Instrucciones

Disengaging the chain brake.
Pull the hand guarad towards the
N
front handle until there is an audible
click – the chain brake is
disengaged.
Fitting the chain
WARNING
Wear work gloves to protect your hands
from the sharp cutters.
Fit the chain – start at the bar nose.
N
MS 461 R
1
3
1
2 4
Fit the guide bar over the studs (1) –
N
the cutting edges on the top of the
bar must point to the right.
Engage the peg of the tensioner
N
slide in the locating hole (2) –- place
the chain over sprocket (3) at the
same time.
Turn the tensioning
N
screw (4)clockwise until there is
very little chain sag on the
underside of the bar – and the drive
link tangs are engaged in the bar
groove.
Refit the sprocket cover and screw
N
on the nuts only fingertight.
Go to chapter on "Tensioning the N
Saw Chain"

Tensioning the Chain

For retensioning during operation:
Switch off the engine
N
Put on protective gloves
N
Versions with depth limiter (special
accessory)
1
2
Loosen adjusting screw (1)
N
Push the slide (2) toward the engine
N
as far as it will go
continue with "For all versions"
N
For all versions
1
Loosen nuts
N
Raise the guide bar at the nose
N
English
29