Cleaning And Maintenance; For Uk Use Only - Petra electric EspressoMahlwerk Instrucciones De Uso

stopped working, pull the receptacle down when taking
out. The ground coffee can be put directly into the filter
of the coffee machine.
When grinding several times, never use for more
than 2 minutes.
In order to avoid a loss of the flavour, only grind the
coffee beans for immediate consumption.
Important note:
If the coffee grinder does not work, the motor might be
blocked by jammed beans. In this case, adjust the
higher grinding degree by regulation wheel. When the
machine has cleared, reset to the desired setting.

Cleaning and maintenance

After use disconnect the appliance.
Never immerse the appliance in water. Clean it with a
damp cloth only. Never use scouring cleansing agents.
Residues of the coffee can be removed with a brush. If
the appliance blocks it is sufficient to grind a little
amount of coffee at highest grain size.
The appliance complies with the European
directives 2006/95/EC, 2004/108/EC and
2005/32/EC.
At the end of its lifetime this product must not be
disposed of through the normal domestic waste,
but it should be handed to an assembly point for
the recycling of electrical and electronical
appliances. You can inquire about details at the
local administration.
Subject to changes.
6

For UK use only

• This product is supplied with a 13 A plug conforming to BS
1363 fitted to the mains lead. If the plug is unsuitable for
your socket outlets or needs to be replaced, please note
the following. If the plug is a non-rewireable one, cut it from
the mains lead and immediately dispose of it. Never insert
it into a socket outlet as there is a very great risk of an
electric shock.
• The replacement of the plug at the mains lead has to be
done according to the following instructions:
Important: The wires in this mains lead are coloured in
accordance with the following code:
blue: Neutral
brown: Live
As the colours of the wires in the mains lead of this
appliance may not correspond with the coloured markings
identifying the terminals in your plug, proceed as follows:
- the wire which is coloured blue must be connected to the
terminal which is marked with the letter N or coloured
black,
- the wire which is coloured brown must be connected to the
terminal which is marked with the letter L or coloured red.
Do not connect any wire to the terminal which is marked
with the letter E or by the earth symbol
green or green and yellow.
• If a 13 A (BS 1363) plug is used it must be fitted with a 3 A
fuse conforming to BS 1362 and be ASTA approved. If any
other type of plug is used, the appliance must be protected
by a 5 A fuse either in the plug or adapter or at the
distribution board. If in doubt - consult a qualified
electrician.
• Never use the plug without closing the fuse cover.
, or coloured