Mounting The Terminal; Panel Mount Enclosure - Mettler Toledo IND780 Guia De Instalacion

4. Once the panel is released, lift the bottom of the panel firmly up and out until it clears the edge
5. Press down on the top of the front panel and push the panel upward, relative to the enclosure,
2.3.

Mounting the Terminal

The Panel Mount enclosure is designed to mount into a cutout of a flat surface such as an
instrument panel or industrial enclosure or door. The harsh enclosure is designed to be placed on a
desktop or can be mounted to a vertical surface with the optional mounting brackets. Mount the
terminal where viewing is optimal and the terminal keypad is easily accessible. Observe location
and environment considerations as described in Chapter 1, Introduction.
2.3.1.

Panel Mount Enclosure

The Panel Mount enclosure comes with a gasket and a backing plate, used to mount the unit to a
panel. The enclosure will mount and seal properly on panel thicknesses from 16 GA to 11 GA
(1.52 mm to 3.04 mm).
Install the Panel Mount enclosure by following these steps:
1. Cut an opening and holes in the panel or industrial enclosure as indicated in the panel cutout
2. Loosen and remove the eight, 8 mm shoulder nuts holding the backing plate to the enclosure.
2-4
METTLER TOLEDO IND780 Installation Guide
of the enclosure.
until the spring retaining clips unsnap. The cover will then be free to swing down, hinged by
two wire cables at its bottom edge.
dimensions shown in Figure 2-3 in inches and [mm].
The gasket should remain in position on the terminal. Figure 2-4 shows two images of the
Figure 2-3: Panel Cutout Dimensions
64057253 | 14 | 08/2014